Loading...
SITCSection 6
U.S. imports of stainless steel hot-rolled flat products, ≥600mm wide, 3mm to <4.75mm thick, not in coils (SITC 67535) totaled $221K in April 2026, traded with 7 countries.
Importers of Stainless Steel Hot-Rolled Flat Products, ≥600mm Wide, 3mm to <4.75mm Thick, Not in Coils paid $110K in duties in April 2026 — an effective duty rate of 50% on $221K in dutiable value, based on actual customs collections rather than the published tariff schedule. Stainless Steel Hot-Rolled Flat Products, ≥600mm Wide, 3mm to <4.75mm Thick, Not in Coils imports of $221K in April 2026 ran 25% below the year-to-date monthly average of $294K.
Last updated: April 2026 dataOccupying the intermediate gauge band between 3 mm and 4.75 mm, this hot-rolled stainless flat product in cut-length (non-coil) form serves fabricators producing heat exchangers, architectural cladding panels, and food-processing equipment where a balance of formability and rigidity is needed. Like all stainless steel flat-rolled imports, it is subject to Section 232 tariffs, and the specific thickness bracket is material to correct HTS classification — misclassifying into the heavier or lighter bracket can alter duty exposure. Precise caliper measurement at the port of entry is a common point of customs examination.
AI-written summary of the official U.S. Census Bureau trade figures on this page — verify before relying on it.
The 3 mm threshold separates this bracket from the under-3 mm category (67536). If measured thickness falls below 3 mm, the product shifts to a different tariff line with potentially different duty treatment. CBP may verify thickness through physical examination, making accurate mill documentation essential.
Heat exchanger fabricators, architectural panel manufacturers, and food and dairy equipment producers are frequent buyers of this gauge. The non-coil form indicates pre-cut plate, which is preferred when downstream fabrication involves heavy shearing or laser cutting rather than roll-forming.
Supplier Network
Get discovered by U.S. importers searching for HS 67535 — Stainless Steel Hot-Rolled Flat Products, ≥600mm Wide, 3mm to <4.75mm Thick, Not in Coils. Be the first supplier listed.
| Country | Imports | Exports | Balance |
|---|---|---|---|
| MEXICO | -- | $441K | +$441K |
| CANADA | -- | $214K | +$214K |
| JAPAN | $114K | -- | -$114K |
| BELGIUM | $107K | -- | -$107K |
| UNITED KINGDOM | -- | $101K | +$101K |
Monthly import values over time