Loading...
SITCSection 6
U.S. imports of cold-rolled stainless steel flat products, ≥600 mm wide, 1–3 mm thick (SITC 67553) totaled $17.4M in April 2026, traded with 23 countries.
Importers of Cold-Rolled Stainless Steel Flat Products, ≥600 mm Wide, 1–3 mm Thick paid $6.0M in duties in April 2026 — an effective duty rate of 40% on $14.9M in dutiable value, based on actual customs collections rather than the published tariff schedule. Cold-Rolled Stainless Steel Flat Products, ≥600 mm Wide, 1–3 mm Thick imports of $17.4M in April 2026 ran 22% above the year-to-date monthly average of $14.3M.
Last updated: April 2026 dataSubject to Section 232 tariffs on steel imports, cold-rolled stainless steel strip and sheet in this thickness band (over 1 mm but under 3 mm) is a workhorse gauge for fabricated components in food processing equipment, automotive trim, and architectural cladding. The 600 mm minimum width threshold places these products in the broad-coil category, distinguishing them from narrower slit strip used in precision roll-forming. Importers should verify mill certifications confirming chromium content and surface finish grade, as these affect both classification and end-use suitability.
AI-written summary of the official U.S. Census Bureau trade figures on this page — verify before relying on it.
Products at or above 600 mm wide fall into the broad-strip/sheet category under SITC 67553, while material slit below that threshold is classified separately. Importers should confirm the as-shipped width before entry, since post-import slitting does not change the classification at time of import.
Cold-rolled stainless steel flat products are subject to Section 232 steel tariffs. Depending on the country of origin, antidumping or countervailing duty orders may also apply. Importers should check the current scope of any applicable orders with CBP or a licensed customs broker before entry.
Monthly import values over time
Supplier Network
Get discovered by U.S. importers searching for HS 67553 — Cold-Rolled Stainless Steel Flat Products, ≥600 mm Wide, 1–3 mm Thick. Be the first supplier listed.